100% taped seams 2-layer coating 5,000 mm Schmerber
Fabric specially coated to reduce the cooling effect of the wind.
2 secure hand pockets, 1 inside pocket Pockets are not waterproof
Breathable coated fabric (RET < 12): reduces condensation 10,000 mm (g/m²/24hrs)
Especially treated so water slides off the fabric surface.
Zip fastenings resistant to salt water and sea air.
Friction-resistant weave 20,000 cycles
Upper part - Main fabric: 100.0% Polyester |
Lower part - Main fabric: 100.0% Polyester |
Main lining: 100.0% Polyester |
Sleeve lining: 100.0% Polyester |
Coating: 100.0% Polyurethane |
This contact is responsible for product safety compliance. For help with an order or return, please contact customer service
DECATHLON
DECATHLON SE
4, boulevard de Mons 59665 VILLENEUVE D’ASCQ
| Raw material | 81% |
| Manufacturing | 4% |
| Packaging | 1% |
| Distribution | 6% |
| Use | 5% |
| End of life | 3% |
It is calculated by modelling the life cycle of the product following the recommendations of the PEF methodology (Product Environmental Footprint). This carbon footprint is an estimate. It may therefore be slightly overvalued or undervalued.Learn more
Upper part - Main fabric: 100.0% Polyester |
Lower part - Main fabric: 100.0% Polyester |
Main lining: 100.0% Polyester |
Sleeve lining: 100.0% Polyester |
Coating: 100.0% Polyurethane |
This contact is responsible for product safety compliance. For help with an order or return, please contact customer service
DECATHLON
DECATHLON SE
4, boulevard de Mons 59665 VILLENEUVE D’ASCQ
Do not dry clean.
Drying in tumble dryer possible. Low temperature, maximum drum exhaust temperature 60°C.
Do not iron.
Maximum washing temperature 30°C. Normal treatment.
Bleaching excluded.
Wash separately for the first wash.
Our anorak went through detailed lab testing to ensure optimal performance.
Waterproofing
The anorak was tested in a 60L/m²/hour rain shower for 2 hours to ensure durability.
We measure fabric waterproofness by its resistance to water pressure in mm (ISO 811 standard). A higher number means better waterproofing.
This jacket's fabric withstands 5,000 mm of water pressure, even after 5 washes, equating to 5,000 Schmerber.
Fabric breathability
To test the breathability of our sailing jacket, we look at evaporative resistance, or RET. This measures how easily moisture, like sweat, can escape from the inside of the jacket to the outside.
Lower RET values mean the fabric is more breathable. If a jacket has a RET of less than 9, it’s considered very breathable. A RET between 9 and 12 means that the jacket is breathable and will help to reduce condensation.
This jacket is made with more resistant fabric, rated at RET < 12.
Waterproof and windproof
Stay dry and protected from sea spray and light rain with built-in weatherproof tech.
Breathable for comfort
Moisture-wicking fabric helps regulate temperature on calm or active sails.
Secure storage at sea
Secure storage at sea
Three zipped pockets, including one inside, keep essentials safe and dry.
Waterproof and windproof
Stay dry and protected from sea spray and light rain with built-in weatherproof tech.
How to reactivate the jacket's water repellency
Drying is essential for reactivating your jacket's water-repellent treatment. We recommend laying it flat on a clothes rack and allowing it to air dry in a well-ventilated area.
Important: Never dry your jacket directly on a radiator.
For best results, place the jacket in the tumble dryer on a short synthetic cycle for 10 to 15 minutes, then turn it right side out.
Note: Avoid over-drying to maintain the integrity of the fabric.
